Netgear Router Installation cannot be completed if you are not receiving any live signals from it. You might be thinking that how it is possible? Well, put the device out of ground and avoid interference from walls and other home appliances. It may also concern you to know that most of the home computer networks consist and deal with one and only valuable router. Using second router does not make any sense and if anyone actually wants an additional device, there could be a few possibilities:

  • To support all the wireless devices by advancement of a wired network.
  • Extending the range of wireless networks to cover the entire dead spots.
  • Catch a wired device that is placed far away from the main router.
  • To create an additional network within the range of home to get video streaming without any interference from other devices and signal breakage.

Making them all done just requires some of the below-given steps:

  1. Positioning of subsequent Router

During the placement of your new router, you are suppose to done this in the notice of your Windows PC or any other wired device that can be used for primary configuration. Both the wired or wireless devices are best to be configured to the router with the help of an Ethernet cable. The new device can be moved later on its intended location later on.

  1. Connection of your second Device

The new router must be connected to the existing one with an Ethernet cable if it does not have the wireless capability. Connect first end of the cable to the WAN or Internet port and the other one to any free port of your existing router. After that you need to grab your smart device (computer or a laptop), launch a web browser and type Netgear Router Default IP into the field of address bar.

  1. IP configuration of a Router

Most of the home network existing or new has their own default IP address depending upon the make and model number of the device. The default setting of the new device does not necessitate any change until it is to be configured. Netgear Router Login requires the IP address if your device (default) to configured as an access point.

Netgear Router Login

  1. Make use of the second router as an Network switch

The above-given procedure enables additional settings of the device in order to support a sub-network within the range of home and devices. These are helpful if you want to preserve a spare level of Internet access all over our devices. It also restricts the interference of neighboring home network. Similarly, the second router can be configured as an access point only if it is wireless. This device does not create a sub-network but on the other hand, it’s normally and easily gets connected with your existing as well as your smart devices too.

  1. Configuration of Second Router without any Support of Sub Network

As a network switch or an access point, in case you want to configure your new router plug an Ethernet cable to any free port which should not supposed to be uplink. No matter the uplink port of your device is free or occupied. Similarly, you are now tending to apply the same process on your existing router. But both the routers should be within the range of each other as well in the range of your other devices too.

Make sure that your existing one should not be overheated and overloaded with large files and the antennas of both the devices should be in proper vertical position. As soon as you found that your device is heating up or about to heat, turn them off immediately and don’t turn them on until they are cool. Also, set the DHCP address of the new router to fit inside the address range of your existing router.